Laboratory compressional wave (VP) and shear wave (VS) velocities were measured as a function of confining pressure for the gabbros from Hole 735B and compared to results from Leg 118. The upper 500 m of the hole has a VP mean value of 6895 m/s measured at 200 MPa, and at 500 meters below seafloor (mbsf), VP measurements show a mean value of 7036 m/s. VS mean values in the same intervals are 3840 m/s and 3857 m/s, respectively. The mean VP and VS values obtained from log data in the upper 600 m are 6520 and 3518 m/s, respectively. These results show a general increase in velocity with depth and the velocity gradients estimate an upper mantle depth of 3.32 km. This value agrees with previous work based on dredged samples and inversion of rare element concentrations in basalts dredged from the conjugate site to the north of the Atlantis Bank. Laboratory measurements show VP anisotropy ranging between 0.4% and 8.8%, with the majority of the samples having values less than 3.8%. Measurements of velocity anisotropy seem to be associated with zones of high crystal-plastic deformation with predominant preferred mineral orientations of plagioclase, amphiboles, and pyroxenes. These findings are consistent with results on gabbros from the Hess Deep area and suggest that plastic deformation may play an important role in the seismic properties of the lower oceanic crust. In contrast to ophiolite studies, many of the olivine gabbros show a small degree of anisotropy. Log derived VS anisotropy shows an average of 5.8% for the upper 600 m of Hole 735B and tends to decrease with depth where the overburden pressure and the age of the crustal section suggests closure of cracks and infilling of fractures by alteration minerals. Overall the results indicate that the average shear wave splitting in Hole 735B might be influenced by preferred structural orientations and the average value of shear wave splitting may not be a maximum because structural dips are <90°. The maximum fast-wave orientation values could be influenced by structural features striking slightly oblique to this orientation or by near-field stress concentrations. However, flexural wave dispersion analyses have not been performed to confirm this hypothesis or to indicate to what extent the near-field stresses may be influencing shear wave propagation. Acoustic impedance contrasts calculated from laboratory and logging data were used to generate synthetic seismograms that aid in the interpretation of reflection profiles. Several prominent reflections produced by these calculations suggest that Fe-Ti oxides and shear zones may contribute to the reflective nature of the lower oceanic crust. Laboratory velocity attenuation (Q) measurements from below 500 m have a mean value of 35.1, which is consistent with previous vertical seismic profile (VSP) and laboratory measurements on the upper 500 m.
1Iturrino, G.J., Ildefonse, B., and Boitnott, G., 2002. Velocity structure of the lower oceanic crust: results from Hole 735B, Atlantis II Fracture Zone. In Natland, J.H., Dick, H.J.B., Miller, D.J., and Von Herzen, R.P. (Eds.), Proc. ODP, Sci. Results, 176 [Online]. Available from World Wide Web: <http://www-odp.tamu.edu/publications/176_SR/chap_05/chap_05.htm>. [Cited YYYY-MM-DD]
2Borehole Research Group, Lamont-Doherty Earth Observatory of Columbia University, PO Box 1000, Route 9W, Palisades NY 10964, USA. iturrino@ldeo.columbia.edu
3Laboratoire de Tectonophysique, ISTEEM, CNRS UMR5568, Université Montpellier II, 34095 Montpellier, Cédex 5, France.
4New England Research, Inc., 76 Olcott Drive, White River Junction VT 05001, USA.
Initial receipt: 17 April 2000
Acceptance: 28 October 2001
Web publication: 23 May 2002
Ms 176SR-018